Configuring the XM weather receiver
1. Plug the XM unit into strong 12v-32v DC power (good power is critical!)
2. Start By making a Bluetooth Shortcut Tap iPaq Wireless on the start screen
3. Tap the Bluetooth tab at the top
4. Bluetooth Connections (that will take you to the my shortcuts in your Bluetooth manager)
5. Click New in the lower left part of the screen
6. Explore a Bluetooth device will already be selected
7. Click Next (It will beginning searching for Bluetooths in the area.)
8. XM BLUE DUN or XM BLUE SPP will appear select it and Click Next.
9. Service Selection will display Bluetooth name (ex. XM RN; XM DATA) highlight name and
UNCHECK the Security box.
10. Click NEXT
11. Click Finish!
DUN Modules:
This will take you back to the short cut page and you should see the shortcut you just created.
1. DOUBLE TAP icon.
2. Dial-up connection screen double tap on New connection
3. Type XM in the connection Name spot (tap the picture of a keyboard to bring it up; located on
the bottom toolbar right in the middle; leave other box’s blank)
4. HIT OK in the TOP corner
5. Connecting (you should see the blinking blue light go steady)
6. Leave User Name, password, domain BLANK
7. Hit Cancel (Its going to come up with a pop up that the connection has failed. That’s FINE!)
8. Tap OK
9. Exit Bluetooth manager
Run Anywhere Map (Start > Programs > Anywhere Map)
Once the map appears, go to File > Settings > WX Settings
Select the box that says XM WX
This will take you to XM Serial Configuration> Select Bluetooth Port 1
Enable XM should be check marked
Click OK
SPP Modules:
This will take you back to the short cut page and you should see the shortcut you just created.
No further action in the Bluetooth Manager is needed. Exit Bluetooth manager
Run Anywhere Map (Start > Programs > Anywhere Map)
Once the map appears, go to File > Settings > WX Settings
Select the box that says XM WX
This will take you to XM Serial Configuration> Select Bluetooth Serial Port Com 5
Enable XM should be check marked
Click OK